Frequently Asked Question

The network projectors use software called EasyMP.

It should be installed on your laptop, but if it is not, put in a ticket and we will install it. 

To use this software, first click on the windows logo in the lower right corner.

Then type easymp in the search window.

Then click on EasyMP Network projection as seen above

On the startup window you will see options for the projector software. You want to click on ADVANCED CONNECTION MODE, and then click the checkbox to make this default, then click OK.

It might ask you to disable the firewall for easymp, if so, click yes.

Be sure to check both button and box as below.

You will now see any projectors on the network that are turned on and set to LAN mode. Your projector should be on the list. If you do not see your projector, make sure it is turned on and in LAN mode. Click the checkbox next to your projector, click the checkbox next to Disable interrupt connection, and then click connect.

If you have saved it under quick connection mode and cannot see any projectors, you need to set it so you can see the initial option screen again. To do so, click on set options.

Then check the box says Display connection mode selection window on startup, then click OK.

Then close the EasyMP program, and start it up again and you will see the initial connection screen.